RL/BL Series Vandal Resistant Emergency Light

AC, AC/DC and Self-powered

WARNING:
Risk of Shock.
Disconnect Power before Installation and Maintenance.

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

  1. All servicing should be performed by qualified service personnel.
  2. Disconnect power at fuse or circuit breaker before installing or servicing.
  3. All electrical connections must be in accordance with local codes, ordinances and the National Electric code.
  4. All unused wires must be capped to prevent shorting.
  5. Do not use outdoors.
  6. Do not let power supply cords touch hot surfaces.
  7. Do not mount near gas or electric heaters.
  8. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
  9. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
  10. Do not use this equipment for other than intended use.
  11. Use caution when handling batteries (self-powered only).
  12. Allow battery to charge for 24 hours before first use (self-powered only).

SAVE THESE INSTRUCTIONS

Installation Instructions

IMPORTANT: Maximum mounting height: 22 feet from floor.

  1. Turn off AC power.
  2. Feed AC unswitched circuit of rated voltage into junction box and leave 6” of wire length.
  3. Using a flat head screwdriver, insert the blade into the slots and tilt to release the latch and open the front cover (see figure 1).
  4. Push in the locking clips located on each side of the reflector and remove the reflector assembly (see figure 1).

Wall and Ceiling Mount

  1. Remove the appropriate knockouts in the back plate.
  2. Feed AC wires through the center hole into the back plate.
  3. Mount and secure the back plate to the junction box. Ensure the gasket is compressed tightly to the surface.
  4. Make the proper connections according to model configuration:
    • For self-powered see figure 3.
    • For AC, AC/DC see figure
  5. Attach safety cable from housing to reflector assembly.
  6. Connect battery connector to PCBA.
  7. Reattach reflector assembly. Push in the locking clips located on each side of the reflector and snap in reflector assembly (see figure 1).
  8. Adjust LED strips as required (see figure 6).
  9. Snap in the lens.

Note: for units with auto-test option, ensure button on lens aligns with test switch on reflector.

NEXT →